Home > Electrical > Switches / Relays >

Newmar Battery Integrator BI-100


Newmar Battery Integrator BI-100


 
MSRP $165.00
Our Price: $147.00
You save $18.00!

Availability:: Usually Ships in 1 to 2 Business Days
Product Code: NEW-BI-100
Qty:

Description
 

Newmar Battery Integrator BI-100

The Battery Integrator causes no voltage drop in the charging system, while the multiple batteries are charged as a single bank whenever a charging source of approximately 13.2 VDC or 26.4 VDC or greater is present (depending on model).

When the alternator or charger is off or a large load causes the voltage to drop below the disconnect point the unit breaks the common tie between the banks. This allows selective battery discharge and prevents “dumping” of a higher-charged bank into a lower-charged bank. The unit may also be activated to connect other batteries through the key starter or a manual switch to provide an added “boost” from the secondary battery whenever the starter is engaged and the unit senses there is sufficient voltage in that battery to provide an assist.

For systems with more than two banks, an isolator must be installed for each additional bank to provide the same isolation and integration as described above.

Features:
• Enables charging of two separate banks without voltage drop, yet maintains 100% isolation at all other times. For systems of three banks or more, an additional unit must be installed for each additional bank
• Heavy duty silver-plated contactor, continuous duty rated to 100 amps
• Voltage sense circuit, epoxy encapsu- lated and heavy duty continuous rated solenoid are all designed for use in marine environments
• 12 volt model has ignition protection rating
• Easy three-wire hook up for two bank systems (BATT +, BATT +, GROUND)
• Terminal for optional wiring of remote light indicating when battery banks are integrated
• Optional internal connection can be wired though key starter or manual over ride switch, tying battery banks together for extra boost during engine start

Specifications:
Models: BI-100; BI-200; BI-24-100
Battery Integration Connect Point: 13.2 VDC (approx.) / 26.4 VDC (approx.)
Battery Disconnect Point: 12.8 VDC (approx.) / 25.6 VDC (approx.)
Maximum Continuous Current: 100 amps (100 amp models) / 200 amps (200 amp model)
Peak Maximum Current: 400 amps (100 amp models) / 600 amps (200 amp model)
Operating Temperature: Control: -40 to +85˚ C / Solenoid: -28 to +48˚ C
Terminals: Battery Connections: 5/16" copper alloy stud
Dimensions: (H x W x D): 3" x 3.25" x 2.5"
Weight: 1 lb.
Approvals: CE Marked

The Battery Integrator is ideal for expanding the single charging output of an inverter/charger to maintain both the house bank and an engine start bank, then to isolate them during inverter function, so current is drawn from the house bank only.

Typical Installation: BI-100; BI-200; BI-24-100


Features
Newmar Battery Integrator BI-100

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Electrical > Switches / Relays