We purchased our current Demo Boat in February of 2020 (Just in time for the Pandemic!) and found that the previous owner had no idea what the Neutra Salt system was for. He kept the boat on a lift a good distance up the St Lucie river, so the engines and exhaust were flushed with mostly fresh water. I reconnected the Neutra Salt systems correctly and added the Neutra Salt solution to each tank. I have been using the system every time we return to the dock. I should probably use it when we anchor overnight, but usually forget to do it.
After finding a few broken/missing hose clamps (Can you believe how cheap the OEM ones are??) and some cracking on the exhaust hoses, I decided to replace all the hoses and clamps. The hoses I purchased came with hose clamps (only one at each end) that were lower quality than the OEM clamps. My preference for all hose clamps on a boat are the ABA type that do not have slots that chew up hoses. The ABA clamps I use are made by Scandvik, and have a 7mm hex head worm. I sure wish my 11-in-One screwdrivers had a 7mm nut driver!
For the hose replacement I decided to pull the exhaust elbows off the twin Volvo Penta 8.1 OSi-D engines to make removal and installation easier, and to inspect the cast iron components. The manifolds and elbows were replaced new in early 2019, so they have been dealing with South Florida seawater for three and a half years. They have been regularly treated with NeutraSalt for about two and a half years. Here are photos of how they looked when they came apart:
I think the manifolds and elbows look pretty good for their age and about 200 hours of use. I cleaned them up and touched up the paint, then reinstalled with new gaskets. They should be good for several more years!
The Boundless Outfitters demo boat is a 2007 Regal 3760 Commodore with twin Volvo 8.1 gas engines that are raw water cooled (yikes!). This is considered to be terrible for boats used in brackish and salt water. Our boat came equipped with Volvo’s Neutra-Salt system installed for both engines. The engines are also equipped with fresh water flushing ports.
The Neutra Salt system is basically a tank with a solenoid valve that allows a small amount of the salt neutralizer to flow into the engine’s raw water cooling water system. The salt neutralizer is teed into the cooling hose prior to the raw water pump, so the solution is dispensed throughout the entire engine, manifolds, and risers. The instructions call for actuating the Neutra-Salt system for 45 seconds before turning off the engine. No fresh water flushing is needed.
I have asked engine repair shops about Neutra-Salt, and have not gotten good answers as to how effective the solution is. Neutra-Salt is expensive at over $50/gallon, so it better work! I decided to perform an experiment to determine the effectiveness, and whether another (cheaper) product could be a fair substitute.
To compare effectiveness of Neutra-Salt in brackish water solution and CRC Salt Terminator in brackish water solution, against fresh water flushing or doing nothing at all.
Three sealed containers were filled with equal amounts of brackish water drawn from Lake Boca Raton. One sealed container was filled with the same amount of fresh water drawn from the boat’s tank.
Two teaspoons of Volvo Neutra Salt was added to one container of brackish water.
Two teaspoons of CRC Salt Terminator was added to one container of brackish water.
One short length of one inch square steel tubing was added to each container.
After 24 hours, the containers were photographed with a flashlight shining to highlight the condition of the steel sample.
After 72 hours, the containers were photographed again in the same manner:
After three days, Volvo Neutra-Salt solution is the clear winner. The steel sample still looks perfectly rust free. The CRC Salt Terminator is somewhat effective, but not quite as effective as Neutra Salt.
I was surprised to see that the sample in fresh water has almost as much rust as the sample in untreated brackish water. That tells me that fresh water flushing has little effect, and is almost as bad as not flushing at all.
Based on this experiment, I strongly recommend the Volvo Neutra Salt system for every gas engine operated in salt water – even those with fresh water cooling. Exhaust manifolds are rarely fresh water cooled on gas engines, and don’t last long (typically 3-5 years). Replacement manifolds, risers and elbows cost upwards of $2000 or more per engine. Using Neutra-Salt will extend the life of these costly components by a significant amount of time.
So far, this experiment has only been running for three days. I will keep it going for a few weeks and update this page.
It would be interesting to determine whether using Neutra-Salt in engines that already have some rust will stop the decay. At the conclusion of the test I will move the sample from the untreated brackish water container to the Neutra Salt container to see what happens.
After one week of soaking steel samples in the various solutions, the only noticeable changes were more oxidation on the three samples that were not in the Neutra Salt solution. Here are the photos:
It is obvious that the Neutra-Salt from Volvo Penta is the clear winner. I am not a chemist, but something significant is happening to protect the steel sample from the ravages of aqueous salt solution.
To learn how an engine that has already suffered some rust will respond to treatment with Neutra Salt, I moved the steel sample from the untreated brackish sample to the Neutra Salt solution, leaving in place the steel sample that had been there all week. After about 18 hours, I took photos:
Original Sample (Lower Left) Formerly Rusted Sample (Upper Right)
I could not believe my eyes! The formerly rusty sample is now clean as a whistle. You can see how the sample that was once rusted has softer edges. I left the raw edges from the cutoff wheel on all the steel samples, as can be seen on the sample at the lower part of the photo. I am truly amazed, and a believer in Volvo Penta’s Neutra Salt!